OREC RABBIT RM60W Instruction Manual page 14

S (P )
TOPPING ARKING
CAUTION
In case parking brake pedal is pressed during the driving, speed control lever quickly comes back to N position
and machine stops. Normally use speed control lever to stop the machine. Especially in high speed, sudden stop
may give physical shock on operator and overload on machine body.
Speed lever
R
N
TIP :
Be sure to use engine switch to stop the engine. In case parking brake pedal is locked and height of cut lever is
in transport position, engine does not stop when opetator leave the seat. However, if the pedal and lever is in
other position, engine stops when operator leave the seat(pilot lamp remains ON and engine switch is in I position).
If the machine is left in such status, battery will get empty. Remember to lock the parking brake pedal, return the
height of cut lever to transport position and turn the key to O position.
After engine is started, engine does not stop if operator is seated regardless of parking brake and height of cut
lever positions.
D
IFFERENTIAL LOCK LEVER CONTROL
Differential lock lever
OFF ON
P
USH MODE
ON
Driving clutch lever
WARNING
1) Except the use in PUSH MODE, alwayd place the driving clutch lever in ON position.
2) For safety, PUSH MODE is recommened for two person or more.
3) On the slope, do not place the driving clutch lever to OFF, because it may cause slipping accident.
OREC RM60W
1) Place the speed control lever to N position and stop the machine.
2) Move the throttle lever to MINI and decrease engine rpm.
3) After 2-3 seconds at MINI position, turn the key to "O" position to stop
engine.
4) Press the parking brake pedal, and lock it with brake stopper.
CAUTION
Machine should be parked on a flat and spacious area, without obstables
F
around the machine. If there is need to park on slope, make sure to use car
stopper. Remove key to avoid theft.
1) Normally operate the machine with differential lock lever in OFF position.
In case of wet ground or steep slope, move the differential lock lever to ON
and lock it.
2) After the machine get out of wet place or steep slope, move back the
lever to OFF position.
On a flat ground, it is possible to push machine without engine power when
driving clutch lever is in OFF position. This is called "PUSH MODE" and it
is recommended in case of engine trouble.
OFF
14