OREC RABBIT RM60W Instruction Manual page 32

S
TRAGE PREPARATION
paint.
6) Put grease and oil where required.
7) Lock the parking brake and store the machine in a flat place under the roof, well ventilated and well dry.
8) In case of placing the cover on the machine, do it only after muffler and engine are cooled. While storing,
regularly check the tire pressure and add air if necessary.
DANGER
1) This product works with gasoline. Fuel leak, smoking near the machine, and making fire may lead to fire
accident.
2) Service the machine in well ventilated place, and store the machine on solid and flat place.
3) Wait more than 5 minutes after stopping the engine and muffler is cooled, to drain the gasoline from fuel tank
or place the cover on the machine.
4) Make sure if there is no flammable item around the machine when running the engine to finish the remaining
gasoline. Keep the place well ventilated.
WARNING
Servicing the machine with grass or dust remaining on the machine, they might be choked and cause engine
overheat.
CAUTION
1) Storing the machine with fuel remaining in the fuel tank or in the carburetor may cause engine starting trouble
or loss of power.
2) For safety, remove the key and keep it at owner.
3) Use of drained fuel in polyethylene tank or use of gasoline kept for more than 3 months may cause engine
trouble. Do not use such fuel.
4) Place the hose, clip or drain bolt in original position if they are removed for service.
5) In case of cleaning the machine with pressure water, pay attention to avoid putting water on electric parts,
carburetor, air cleaner and muffler. Otherwise, it leads to engine starting trouble.
TIP :
It is easy to remove grass inside the blade cover, if they are washed with pressure water before grass get dry.
-Storing in cold region-
1) During winter, clean the machine and remove mud and obstacles after the use. Park the machine on flat and
dry surface. Otherwise, they might be frozen on the machine and cause machine trouble.
2) In case machine is parked on flat surface, do not lock the parking brake pedal, and use tire stopper to avoid
sticking of brake shoe.
3) In case machine is frozen and it is impossible to drive, do not attempt driving and put hot water on frozen
part and wait until it melts.
N
OTICE FOR NEXT USE
1) Use fresh fuel.
2) Execute pre-use inspection.
3) Make sure if each control levers work properly(before every use).
4) Make sure if all bolts and nuts are not loose and in place.
OREC RM60W
on 1)
remove the gasoline from fuel tank to prevent fuel from degrading.
Then start the engine and keep it running until the rest of gasoline
off
is burned out.
2)
fuel cock.
3)
4)
5)
grass and dust around the rotating screen, exhaust system, air
cleaner, muffler, HST fan cover, carburetor and inside the belt
cover. If there is rusty part, remove the rust and spray the anti-rust
In case the machine is not in use for more than 30 days,
Turn the engine switch key to O position and close the
Clean the outside of machine and engine.
Replace the engine oil.
Clean each part of machine. With air blower, clean the
CAUTION
32