OREC RABBIT RM60W Instruction Manual page 26

Belt holder(pic.2)
O
FFSET BELT ADJUSTMENT
Tension spring
Lock nut
B
About 60mm
B
LADE BRAKE ADJUSTMENT
Lock nut
OREC RM60W
Adjust the gap between belt holder of engine pulley and back of best to
be 4-5mm.
Refer to figure(left) and adjust the nut.
1) If tension is not enough,
-adjust the nut toward A.
2) If tension is too much,
-Adjust the nut toward B.
Adjust nut
Normally, length of tension spring is about 60mm(free length of
spring is 52mm).
A
Take same way to adjust offset belt in right and left.
1)
to OFF( ) position. If not, loosen the lock nut and adjust it by mov-
ing the adjust nut of brake wire in direction of arrow. Wrong adjust-
ment may lead to machine trouble. After the adjustment, securely
tighten the lock nut.
2)
out. Contact your nearest dealer for inspection and replacement.
Adjust nut
Blade stops in 5 seconds when the brake clutch lever is moved
If it is not possible to make adjustment, brake shoe may be worn
26