Installing The Cable Retention Bracket - Dell E31S Series Owner's Manual

Related tasks
Before working inside your system
Removing the cooling shroud
Removing the PCIe card holder

Installing the cable retention bracket

Installing the cooling shroud
Installing the PCIe card holder
After working inside your system
Related reference
Safety instructions
Installing the cable retention bracket
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. If installed, remove the cooling shroud.
4. Remove the PCIe card holder.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow
the safety instructions that are shipped with your product.
Steps
1. Align the cable retention bracket with the alignment pins on the chassis.
2. Slide the cable retention bracket along the chassis wall until the tab clicks and locks the keyhole slots.
3. Place all cables to be routed in the cable retention bracket.
Figure 29. Installing the cable retention bracket
1. alignment pin (2)
3. tab
Next steps
1. Install the PCIe card holder.
2. Install the cooling shroud.
3. Follow the procedure listed in the After working inside your system section.
84 Installing and removing system components
2. keyhole slot
4. cable retention bracket