Installing The Cable Retention Bracket - Dell EMC PowerEdge R730xd Owner's Manual

Steps
1. Pull the tab to release it from the notch and slide the cable retention bracket toward the front of the chassis to release it
from the chassis.
2. Lift the cable retention bracket out of the chassis.
Figure 48. Removing the cable retention bracket
a. alignment pin (2)
b. tab
c. cable retention bracket
Next steps
1. Install the cable retention bracket and reconnect all cables routed through the cable retention bracket.
2. If removed, install the PCIe card holder.
3. If removed, install the cooling shroud.
4. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 67
Related tasks
Before working inside your system
Removing the cooling shroud
Removing the PCIe card holder

Installing the cable retention bracket

Installing the cooling shroud
Installing the PCIe card holder
After working inside your system
Installing the cable retention bracket
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. If installed, remove the cooling shroud.
4. Remove the PCIe card holder.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
on page 68
on page 75
on page 107
on page 111
on page 76
on page 108
on page 68
Installing and removing system components 111