Table of Contents
Advertisement
Using the Operation Panel
Important
The weekly timers do not work if the main power switch is turned off or the
power cord is unplugged.
When the power is off due to the activation of the weekly timer, you can tem-
porarily cancel the power off state by entering the key operator code (up to 8
digits) set in "Key Operator Code for Off Setting".
Interface Settings/Parallel Interface
Menu
Parallel Timing
5
Parallel Communication
Speed
Selection Signal Status
Input Prime
Bidirectional Communi-
cation
Signal Control
68
Description
Specifies the timing setting for the parallel interface. Under normal
circumstances, you will not need to change this setting.
Note
Default: ACK Outside
Specifies the communication speed for the parallel interface. If the
communication speed is set too fast, data transfers may not flow
smoothly. If this occurs, change the setting to "Standard".
Note
Default: Standard
Specifies the level for the select signal setting of the parallel inter-
face.
Note
Default: High
Specifies whether the prime signal is active or inactive when an in-
put prime signal is sent. Under normal circumstances, you will not
need to change this setting.
Note
Default: Invalid
Specifies the printer's response mode etc., for status request when
using the parallel interface. If you experience problems when using
other manufacturers printers, set this to "Off". However, if this is set
to "Off", asynchronous functions will not work.
Note
Default: Yes
Specifies the error processing settings for when an error occurs
when printing from a computer or sending faxes. Under normal cir-
cumstances, you will not need to change this setting.
Note
Default: Job Acceptance Priority
'UDIW
Advertisement
Table of Contents
