Table of Contents
Advertisement
Troubleshooting
Messages/Second messages
Remove Misfeed
Duplex Unit
/ Open Duplex
Unit Cover
Replace the Scanning Com-
ponent)
Reset Duplex
Unit Correctly
Resetting Job...
4
RPCS graphic error
RPCS memory overflow.
Selected paper tray is in use
for another function. Please
wait.
Staple has been cancelled
Staple is almost empty.
Staple is almost empty.
Staple unit has a problem.
Call service representative.
Staple unit is in use for an-
other function. Please wait.
The paper is remaining in the
Finisher. Open the cover and
remove the paper.
The tray on the finisher is
malfunctioning. Contact
service representative.
Toner Is Almost
Empty
Unauthorized user access.
Print job has been cancelled.
44
Descriptions and Solutions
There is misfeed in the Duplex Unit.
Remove the misfed paper.
The Scanning component has to be replaced. Contact your serv-
ice representative.
The optional Duplex Unit is not set correctly.
An error has occurred in the Duplex Unit.
Set the optional Duplex Unit correctly. If the message appears
again, call your sales or service representative.
The print job is being reset.
Wait for a while.
There is the possibility that the SDRAM is not working correct-
ly. For details, contact your service representative.
There is the possibility that the SDRAM module is not working
correctly. For details, contact your service representative.
The selected paper tray is being used by another function such
as copy. Please wait until the other function has completed us-
ing the selected paper tray.
Check the paper direction, printing direction as well as the post-
process positioning settings.
There are a few staples remaining.
Please set in more staples.
There are a few booklet staples remaining.
Please set in more booklet staples.
The staple unit is malfunctioning.
Contact your service representative.
The staple unit is being used by another function such as copy.
Please wait until the other function has completed using the sta-
ple unit.
Remove the paper remaining inside the Finisher.
Malfunction occurs when using the Shift function. Contact your
service representative.
The toner is almost run out.
Prepare a new toner cartridge. If the image density gets too
light, replace the toner cartridge with a new one.
Check the User Code permission conditions.
'UDIW
Advertisement
Table of Contents
