Using The Test Video Plus Analog Audio Card; Defining The Test Video Plus Analog Audio Card - Kramer VS-1616DN-EM User Manual

Using the Test Video Plus Analog
Audio Card

Defining the Test Video Plus Analog Audio Card

The Test Video Plus Analog Audio card is a 2-Input/Output DVI with Analog Audio Card
(F-16), preinstalled in the
Figure 3 for more information). For information on using the Test Video Plus Analog Audio
card for troubleshooting audio and video problems, see
Troubleshoot Video and Audio Problems
Test Video Plus Analog Audio Card Configuration
The Test Video Plus Analog Audio card configuration table appears as follows when
configured as an input card:
Test Video Plus Analog Audio Input Card
Parameter Description
Reset Input Re-power—Power cycles the port.
Factory—Performs a factory reset to default values of the port.
Audio Selects the audio source:
Select
Auto—Audio signal selection is controlled by the presence or absence of a plug
in the 3.5mm mini jack. When present, AUD-Analog is selected, when absent,
AUD-Embedded is selected.
AUD-Embedded—HDMI audio is selected.
AUD-Analog—Analog audio is selected.
Volume Sets the audio output volume (0–70).
Note: Not applicable when digital audio is selected.
Audio Sets the audio output channel balance (0–100).
Balance
Note: Not applicable when digital audio is selected.
Audio Bass Sets the audio output bass level (0–15).
Note: Not applicable when digital audio is selected.
Audio Sets the audio output treble level (0–15).
Treble
Note: Not applicable when digital audio is selected.
Audio Mute MUTE—Mutes the audio input.
Non-MUTE—Unmutes the audio input.
Note: Not applicable when digital audio is selected.
VS-1616DN-EM – Using the Test Video Plus Analog Audio Card
VS-1616DN-EM for initial setup and installation purposes (see
on page 89.
Kramer Electronics Ltd.
Using the Test Module to
Default
Re-
power
Auto
50
50
7
7
Non-
MUTE
38