Kramer VS-1616DN-EM User Manual page 10

10 DEFAULT SETUP Button
11 IR Receiver
12 IR LED
13 PS-1 POWER LED
14 PS-1 ERROR LED
15 TAKE Button
16 MENU Button
17 LOCK Button
18 OUTPUTS/INPUTS
LCD Display
19 Front Panel Locking Screws
20 Power Supply Thumbscrews
# Feature
◄ (Backward)
21
22 1, 2, 3, 4, 5, 6, 7, 8,
9, 0
► (Forward)
23
VS-1616DN-EM – Introduction
Press to recall the default setup (see
Setup
Infrared remote control sensor (for future use).
Lights yellow when receiving commands from the IR
remote control transmitter (for future use).
Lights green when power supply is active.
Lights red when an error is detected. Briefly lights red
immediately following a power disruption (e.g., cable
disconnection, power off, and so on).
Press to confirm actions (see
Action
Press once to enable the ALL, OFF, STO and RCL buttons
(see
Press again to enter the configuration menu (see
Config Menu
When in a Menu, press to cycle through the menu items.
Press and hold for approximately 2 sec to lock/unlock the
front panel buttons (see
Buttons
Displays the outputs (upper row) switched to the selected
inputs (lower row), (see
Displays user interface messages and menus.
Release the 14 front panel locking screws to open the front
panel and access the fan arrays (see
16DN Fan Array
Release the 4 power supply thumbscrews to install /
remove the PS-16DN power supply (see
16DN Power Supply
Figure 2: VS-1616DN-EM Front Panel Numeric Keypad
Function
Press to shift the sliding window to the right (the LCD display only shows 13
cross-points out of a total of 16).
Numeric keypad, 1 to 0.
Press to shift the sliding window to the left (the LCD display only shows 13
cross-points out of a total of 16).
on page 21).
on page 19).
Using the Configuration Menu
on page 27).
Locking the Front Panel
on page 22).
Startup Display
on page 95).
on page 96).
Kramer Electronics Ltd.
Recalling the Default
Confirming a Switching
on page 23).
Using the
on page 17).
Replacing a FAN-
Installing a PS-
7