Integrated Peripherals Page - VIA Technologies VT82C686A User Manual

Mainboard User's Manual

Integrated Peripherals Page

This page sets some of the parameters for peripheral devices
connected to the system.
CMOS Setup Utility – Copyright (C) 1984 – 2000 Award Software
On-Chip IDE Channel0
On-Chip IDE Channel1
IDE Prefetch Mode
Primary Master PIO
Primary Slave PIO
Secondary Master PIO
Secondary Slave PIO
Primary Master UDMA
Primary Slave UDMA
Secondary Master UDMA
Secondary Slave UDMA
Init Display First
IDE HDD Block Mode
Onboard FDD Controller
Onboard Serial Port 1
Onboard Serial Port 2
UART 2 Mode
x IR Function Duplex
x TX,RX inverting enable
    : Move
Enter : Select
F5:Previous Values
On-Chip IDE Use these items to enable or disable the PCI IDE
channels that are integrated on the mainboard.
Channel 0,1
Primary/ Each channel supports a master device and a
slave device. These four items let you assign
Secondary
which kind of PIO (Programmed Input/Output) is
Master /Slave PIO
used by IDE devices. You can choose Auto, to let
the system auto detect which PIO mode is best, or
you can install a PIO mode from 0-4.
Primary/
Each channel supports a master device and a
slave device. This motherboard supports
Secondary
UltraDMA and provides faster access to IDE
Master /Slave
devices. If you install a device that supports
UDMA
UltraDMA, change the appropriate item on this list
to Auto. You may have to install the UltraDMA
driver.
Init Display First
Use this item to define if your graphics adapter is
installed in one of the PCI slots or select Onboard
32
Integrated Peripherals
Enabled
Enabled
Enabled
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
PCI Slot
Enabled
Enabled
Auto
Auto
Standard
Half
(No, Yes)
+/-/PU/PD:Value: F10: Save ESC: Exit F1:General Help
F6:Fail-Safe Defaults F7:Optimized Defaults
Item Help
Menu Level