Mounting Procedure - Kanardia Horis Installation And User Manual

Horis User Manual

2.2 Mounting Procedure

Figure 1: Screw can damage LCD screen behind the mask.
When you use your own M4 screws, please make sure that screw will
never touch the LCD screen behind the front mask. Cut the screw
to proper length when necessary.
2.2 Mounting Procedure
The mounting screw holes are located on a circle of 66/89 mm diam-
eter. The instrument is mounted using three screws type M4 and one
1
M6 insert . To prevent internal stresses, please make sure that the
instrument panel is flat. The fourth hole is used for the knob axle.
Figure 4 illustrates the mounting hole.
Remove the mounting screws from the instrument and then remove
1
Only Horis 80 mm.
© Kanardia 2021
14