Installation & Maintenance; Mounting Dimensions; Connections - Kanardia Digi Manual

Digi — Manual
interface module and Kanja Android app are also required to transfer
the layout into the Digi.
A layout is put on Digi in the following steps:
1. Use the Customizer app on your PC to create the layout.
2. Transfer the resulting layout file to your Android device.
3. Insert the Blu module into Digi and use the Kanja app to copy
the layout file to Digi.
Please refer to the Customizer manual for details about how to crate
the layout and to the Kanja manual for details about how to work
with Android device.
3 Installation & Maintenance
3.1

Mounting Dimensions

Digi requires a 108 x 70 mm rectangular hole in the instrument panel.
The position of the hole must ensure that the instrument is always
visible from the pilot's perspective.
The instrument is mounted using four M3 screws, washers and nuts.
To prevent internal stresses, please make sure that the instrument
panel is flat. It is recommended that the instrument panel is mounted
using rubber shocks, which reduce the vibrations.
Figure 1 illustrates panel cutout and mounting holes for Digi instru-
ment.
3.2

Connections

Figure 2 illustrates all connections at the back side of the instrument.
There are only two RJ45 CAN connectors and one power connector.
3. Installation & Maintenance
6
©
Kanardia 2017