Kanardia Horis Installation And User Manual page 15

Horis User Manual
Notice LCD behind the bezel.
Too long screw will break it.
Figure 2: Example of broken LCD screen. Edge of the LCD display
is visible behind the bezel.
the knob. Use finger nail or sharp knife to remove the cap from
the knob, but be careful not to cut the cup away. Once the cap is
removed, use flat screwdriver and loosen the screw. Slide the knob
from its axle. Figure 3 shows an example of the knob with its cap
removed.
Figure 3: Photo of the knob with its cap removed.
Some older Horis 80 have an additional M6 nut that is used as an
axle guide. This nut must be also removed.
Insert the instrument from the back side of the instrument panel.
Fix three mounting screws. In the Horis 80 case, fix also the M6
nut (axle guide). Then insert the knob back to the axle, tighten the
knob. Please make sure it does not rub the panel and ensure that
2.2 Mounting Procedure
15
© Kanardia 2021