Turn Rate - Kanardia Horis Installation And User Manual

Horis User Manual
4.6.9

Turn Rate

Horizontal turn rate bar that appears on the AHRS screen can have
different sensitivities:
• Standard 3 /s (two minutes turn),
• Double 6 /s (one minute turn),
• Glider 12 /s (30 seconds turn).
This selection defines the inner dot of the turn rate bar. So, if you
want to keep the correct turn rate, you have to aim to the inner dot.
The outer dot defines twice the turn rate of inner dot.
Altitude
In order to set the altitude offset you need a reference altimeter. Set
the QNH on Horis and reference altimeter to the same value, say
1013 hPa.
• Use the knob to select the altitude offset frame. This is already
selected when the window is opened.
• Push the knob to start the offset.
• Rotate the knob in order to match the altitude shown below
the frame with the altitude shown by the reference altimeter.
Horis shows two values: Pst is the static pressure and is shown
in hPa and Alt is the altitude shown in metres. These metric
units are used regardless the units selected by user.
• Push the knob to finish editing and wait for timer to close the
window.
52
4.6 Settings
© Kanardia 2021