Windows Nt 3.5X & Nt; Installing Driver In Existing Windows Nt System - Promise Technology FASTTRAK66 User Manual

Manual EN 05-08-1999 11:30
Operating System Installation
Windows NT 3.5x and NT 4.0
FastTrak66 supports operation under Windows NT 3.5x and later versions.
Driver Installation During Windows NT 3.5x and NT 4.0 Install
1a) Floppy Install: Boot the computer with the Windows NT installation
diskettes.
1b)Floppyless Install: Boot from floppy and type "WINNT /B". After files
have been copied, the system will reboot. On the reboot, press <F6> when
the message
configuration..." appears.
1c) CD-ROM Install: Boot from the CD-ROM and press <F6> when the
message "Setup is inspecting your computer's hardware configuration...".
2) Press "S" to add a SCSI adapter.
3) Select "Other (requires disk provided by hardware
manufacturer)."
4) Specify "a:\", insert the Promise driver diskette into drive A: and press
ENTER.
5) Select the "Promise Technology Inc. FastTrak66 RAID Controller" and
click "OK". Note: for CD installations, you must also specify the driver for
your CD-ROM adapter (i.e. if using an ATAPI CD-ROM, specify the IDE
2.1 controller)
6) Follow the normal setup installation procedure.
Installing Driver in an Existing Windows NT System
If you will be attaching an existing drive to FastTrak66 that was already instal-
led under a Windows NT installation, you must follow the steps to install the
FastTrak66 NT Driver BEFORE you move the drive from your current IDE
controller.
Pagina 53
"Setup is inspecting your computer's hardware
53