Controller Configuration - Promise Technology FASTTRAK66 User Manual

Manual EN 05-08-1999 11:30
FastBuild™ Configuration Setup
Controller Configuration <6>
This menu allows you view and set the adapter options.
Fastbuild™ Utility 1.xx (c) 1995-99 Promise Technology, Inc.
Ultra ATA Mode:
Halt On Error:
Channel 1 (IDE1)
Channel 2 (IDE2)
[ ] Up [ ] Selection
[Adapter Configuration - Options]
Ultra ATA Mode -- sets the disk DMA burst rate. "Auto" is the default setting
to optimize system performance. "Turbo" forces the fastest data rate. The
"Fast" setting operates for reliable mode.
Halt On Error -- allows FastTrak66 to Halt operation at the BIOS startup
screen should an error be detected.
[ System Resources Configuration]
This section displays the PCI slot interrupt and port address used by the
FastTrak66. The resources used are determined by the Mainboard PCI PnP
BIOS for the PCI slot in which the FastTrak66 resides. In the rare case that
there is a resource conflict, refer to the Mainboard BIOS documentation on
changes on resources allocated to the FastTrak66 PCI slot.
Pagina 29
[ Adapter Configuration - Options ]
Auto
Enable
[System Resources Configuration]
Interupt : A
Interupt : A
[ Keys Available ]
[ , , Space] Change Option [ESC] Exit
29
I/O Port : FFF0
I/O Port : FFA8