Soft Ceiling Tile Installation - ETC Echoflex Elaho Installation Manual

Echoflex Installation Guide
Dual Tech Ceiling-mount Vacancy Sensor

Soft Ceiling Tile Installation

Ceiling tile
adapter
1. Pull the Belden 8471 (or equivalent) and 2.5 mm
wire to the mounting location and strip each wire 11 mm (7/16 in).
2. Temporarily remove the sensor cover to gain access to the
configuration switches and mounting access holes. Hold the sensor in
one hand while gently twisting the cover clockwise.
3. Prepare the ceiling tile.
a. Align the flat side of the sensor to the finished side of the ceiling
b. Remove the ceiling tile material from marked access hole.
c. Pull the sensor wires through the access holes to the unfinished
4. Secure the sensor in place.
a. Insert the soft ceiling tile adapters through the provided pinholes
b. Push the adapters through the ceiling tile, and then bend each
5. Connect the EchoConnect wires from the sensor to the installed wires.
a. Connect the data - EchoConnect wire (black) from sensor to the
b. Repeat the above step for the data + EchoConnect wire (white)
Dual Tech Ceiling-mount Vacancy Sensor
tile and mark the center access hole for wire pass-through.
side of the ceiling tile.
on the sensor, one set located on each side of the sensor near the
mounting keyholes.
tine over in opposite directions for a secure fit on the unfinished
side of the ceiling tile.
incoming data - EchoConnect (typically black) wire using a WAGO
wire termination connector (provided).
and for the ESD ground wire (typically green/yellow), using a new
WAGO connector for each termination type.
Page 5 of 12
Ceiling tile
Ceiling tile adapter
2
(14 AWG) ) ground
Echoflex