Set Space And Address - ETC Echoflex Elaho Installation Manual

Echoflex Installation Guide
Dual Tech Ceiling-mount Vacancy Sensor
Settings
The Elaho Dual Tech
Ceiling-mount
Vacancy Sensor
participates in an
Elaho control system
using the configured
Space and Address,
which are selectable
using the rotary
switches on the sensor electronics located behind the removable cover.
Note:
DIP switch 2 set to On, all other DIP switch settings are ignored.
Note:
are not used and have no functionality on the Dual Tech Ceiling-
mount Vacancy Sensor.

Set Space and Address

Two rotary switches on the sensor electronics provide for Space and Address
assignment for the sensor. By default, these switches are set to Space 1,
Address 1. Commands are shared by all devices within a given space.
1. Set the Space rotary switch to the desired number (1 through 16) for
the space you want the sensor to control.
2. Set the Address rotary switch to desired address (1 through 16) for the
sensor identification in the selected space.
Note:
Dual Tech Ceiling-mount Vacancy Sensor
When the sensor is placed into Custom configuration mode,
The [MODE] and Auxiliary [A] buttons, and their related LEDs,
Do not duplicate a device Address within the same Space.
Page 6 of 12
DIP switches
Space and Address
switches
Echoflex