Setting Autoranging - Siemens SIPROCESS GA700 Quick Start Manual

Commissioning: Sequence
8.6 [1.4] Measuring ranges
4. Enable/disable measuring range: "Use measuring range" parameter field.
Note
Using measuring ranges in other device functions/menus
Other device functions or menus can only access measuring ranges activated in this
menu. Inactive measuring ranges are not displayed for selection in other device
functions/menus. This means they can no longer be used, for example, in autoranging or
in calibrations.
5. Set additional measuring ranges/parameters, e.g., → Setting Autoranging (Page 98).
8.6.3

Setting Autoranging

Procedure
Note
Autoranging
Autoranging is not possible if the measuring ranges were set incorrectly. In this case
measuring range 1 is selected as active measuring range.
Note
Component-specific setup
Measuring ranges are component-specific. Repeat the procedure described below for all
components, if necessary.
98
Compact Operating Instructions, 06/2017, A5E31805656-05
Quick Start