Siemens SIPROCESS GA700 Quick Start Manual page 72

Operation
6.1 Local User Interface (LUI)
To display detailed information about the current messages in the main view, follow the
steps below:
1. If necessary, open the main view:
– To do this, press the <MEAS> key.
– Follow the instructions on the display.
2. Display the list of current messages (display 4/4) in the main view:
– To do this, use the <▼>/<▲> keys.
3. Activate the selection mode:
– Press <ENTER>.
4. Display detailed information:
– Select one of the displayed messages with the <▼>/<▲> keys.
– Confirm your selection by pressing the <ENTER> key.
– If required, acknowledge the message and eliminate the causes named in the
Log on/log off (PIN)
All device parameters are assigned to one of four user levels. You do not need to log on for
the lowest user level. But write access to parameters always requires the corresponding
authorization for security reasons:
Protected parameters are identified by the symbol
parameter or start a wizard, you are prompted in a window to enter a PIN of the currently
required user level. The PIN consists of four numbers each of which is represented by a *
during input.
The PIN numbers shown in the table are factory settings. For your own safety, we
recommend that you change these PIN numbers.
The currently selected user level remains set until you log off or select a higher user level. As
long as you are logged on, the device is locked for other write accesses, for example,
SIMATIC PDM via Ethernet.
When you log off (2 x <MEAS>), you can either accept the changes or discard all of them.
72
Detailed information about the message is displayed.
message text.
. If you want to edit a protected
Compact Operating Instructions, 06/2017, A5E31805656-05
Quick Start