Table of Contents
Advertisement
If the sensor is replaced while the download function is ON, measurements can-
not be taken correctly with the new sensor, because the old sensor information
(such as the measurement range) is still stored.
Refer to page 146 in the Operation Manual.
Environment
The Sensor cannot accurately detect the following types of objects:
* Objects with an extremely low reflection ratio
* Objects with a small curvature
* Largely inclined objects
Component Installation and Handling
Components
The Sensor and Console must be products designed specifically for the Z500.
Connecting Cables
Always turn OFF the Z500's power before connecting or disconnecting cable.
Touching Signal Lines in Connectors or Terminals
To prevent damage from static electricity, use a wrist strap or another device for
preventing electrostatic discharges when touching terminals or signal lines in
connectors.
Wiring
When using a transformer for the Z500's driving power supply, use an isolation
transformer in the way shown below. Do not use an auto-transformer. Doing so
may result in equipment failure.
REFERENCE
• Sensor (Z500-SW2T, Z500-SW6, Z500-SW17)
• Console (Z300-KP)
Auto-transformer
Commercial
power supply
Isolation transformer
Commercial
power supply
INTRODUCTION
Z500-MC10
Z500-MC10
Z500
Setup Manual
15
Advertisement
Table of Contents
