Omron Z500-SW2T Setup Manual page 78

Profile measuring system

Table of Contents

SECTION 4

Appendix

Z500

Setup Manual

Footnotes:

Note 1: Based on highest level accessible during operation.

Note 2: Required wherever & whenever human access to laser radiation above Class I

limits is not needed for product to perform its function.

Note 3: Required for protective housings opened during operation or maintenance, if

human access thus gained is not always necessary when housing is open.

Note 4: Interlock requirements vary according to Class of internal radiation.

Note 5: Wording depends on level & wavelength of laser radiation within protective hous-

ing.

Note 6: Warning statement label.

Note 7: CAUTION logotype.

Note 8: Requires means to measure level of laser radiation intended to irradiate the

body.

Note 9: CAUTION if 2.5 mW cm

Note 10: Delay required between indication & emission.

Note 11: Variance required for Class IIb or IV demonstration laser products and light

shows.

Note 12: DANGER logotype.

Note 13: Required after August 20, 1986.

or less, DANGER if greater than 2.5 mW cm

-2

Table of Contents

Z500-sw6 Z500-sw17