Omron Z500-SW2T Setup Manual page 27

1-3-3 Connecting a Sensor
Be sure to attach the three ferrite cores (the sensor's accessories) to the sensor
cable. Two ferrite cores should be attached to the cable within 100 mm of the
controller's SENSOR connector, and another two should be attached within 100
mm of the sensor.
100mm max.
Ferrite core
(Attached to the sensor when the sensor is shipped)
Shift the position of the core, if necessary
When using an extension cable, attach two ferrite cores to the cable within 100
mm of the sensor, and another two within 100 mm of the controller's connector.
100mm max.
Ferrite core
(Attached to the sensor when the sensor is shipped)
Shift the position of the core, if necessary
Ferrite core (accessory)
Ferrite core (accessory)
SECTION 1
Wiring and Connection
100mm max.
Ferrite cores (accessories)
100mm max.
Ferrite cores (accessories)
Setup Manual
SENSOR
SENSOR
Z500
25