Omron Z500-SW2T Setup Manual page 25

Two, M2 × 4
1-2-2 Controller
Z500-MC10E/MC15E
7. Ground terminal
Z500
MULTI-DIMENSION CONTROLLER
17. POWER
indicator
16. RS-232C
connector
15. DIP switch
Shading indicates parts that are lifted to see the terminals underneath.
10. Connected to external devices such as a PLC.
11 Connected to the monitor.
12. Connected to a console.
13. Connected to the sensor.
14. Connected when using analog output.
15. Do not use. (Turn OFF the DIP switch.)
16. Connected to external devices such as a personal computer or PLC.
17. Lit while power is ON.
Beam cover attached
Lever screws:
M2 × 5
9. Output terminals
8. Power Supply
terminals
14. Analog output
terminals
13. Sensor connectors
7. Connected to the ground wire.
8. Connected to the power supply.
9. Connected to external devices such as a PLC.
Beam cover removed
10. Input terminals
9. Output terminals
Do not open.
12. Console connector
SECTION 1
Wiring and Connection
Monitor cap
(provided as an accessory)
11. Monitor connector
Do not remove the
sticker on the side.
Z500
Setup Manual
23