HYOSUNG MoniMax 5600T Operator's Manual page 145

MoniMax 5600T
● Physical Installation
To install the Model MoniMax 5600T ATM, perform the following steps.
1) Height adjustor in this machine is the default type. Keep in mind that height adjustor and wheel
have the same hole location at the bottom. If you want to install the anchor bolt at the installation
site, place the " Anchor bolts locate sheet " at the place where the machine is to be installed. (refer
to Fig. 6.9)
2) Place the system on a flat surface. Be careful when opening the top or bottom of the machine
because it can be off balance
3) Place the Anchor nuts into the ground according to the anchor bolts locate sheet. (4 places)
4) Place the Model MoniMax 5600T ATM on top of the sheet.
5) Open the Security cover with the key provided.
6) Using the supplied combination (factory preset at 50-25-50 or 1-2-3-4-5-6) open the Security Door.
This combination should be changed as soon as possible. Refer to Chapter 4 for instructions on
changing the lock combination.
7) After the anchor nuts are in place according to the anchor holes on the bottom of
the MoniMax 5600T ATM, tighten the anchor bolts tightly.
6 - 50
6. Appendix