HYOSUNG MoniMax 5600T Operator's Manual page 114

MoniMax 5600T
2) Receipt Printer
Error Code
In case of detecting to be open lever of
2010100
print head before printing receipt paper
In case of detecting to be overheated in
2010200
print head before printing receipt paper
Paper jam occurs in return path before
2010300 printing or cutting or discharging receipt
paper
It is detected that paper is empty before
2010400
printing receipt printer
It is detected that paper is not properly
2010500
set before printing
Command is received while doing self-
2010600
test
2010700 Receipt paper runs out of before printing
It is detected that paper is not properly
2010800
cut while operating
Black mark is not properly detected in
2010900
receipt paper before printing
The size of image print data is abnormal
2010A00
while printing image
In case of detecting to be open lever of
2080100
print head after printing receipt paper
In case of detecting to be overheated in
2080200
print head after printing receipt paper
Paper jam occurs in return path after
2080300
printing
receipt paper
It is detected that paper is empty after
2080400
printing receipt printer
It is detected that paper is not properly
2080500
set after printing
Command is received while doing self-
2080600
test
Cause
or cutting or discharging
1.Close the lever of print head completely
1.Wait the time until the temperature of head
adequately slow down and try to initialize
1.Remove jammed paper between printer head and
rollers
1.Replenish receipt paper
2.Check the status of sensor and its connctor
1.Check the status of setting paper
2.Check the status of sensor and its connctor
1.After terminating self-test and initialize receipt
printer
1.Replenish receipt paper in paper charger
2.Check the status of Near End sensor and its
connctor
1.Check the Cutter module
2.Check if printer head lever is properly close
1.Check the status of Black mark sensor
2.Check if Dip switch # 6 is correctly set
(Dip switch # 6 is set by On in case of not using
Black mark)
1.Check the AP version and initialize
1.Close the lever of print head completely
1.Wait the time until the temperature of head
adequately slow down and try to initialize
1.Remove jammed paper between printer head and
rollers
1.Replenish receipt paper
2.Check the status of sensor and its connctor
1.Check the status of setting paper
2.Check the status of sensor and its connctor
1.After terminating self-test and initialize receipt
printer
6 - 19
6. Appendix
Handling