HYOSUNG MoniMax 5600T Operator's Manual page 124

MoniMax 5600T
Error
Code
Dispensing 0 sheets required is
4004900
error(Separated rejection)
TIME
4004A00
rejection)
Continuous 10 times error if note is
4004B00
long
Detected the remaining notes on the
4004E00 return path during dispense reserved
operation
Received a request for over 121
4005100 notes dispensing on the CDU from
the upper unit.
The remaining notes at the sensor in
front of the CST after dispense
4005200
operation
CS31AB, CS41AB)
4005400 CS1 Sensor Table Search Error
Timeout due to note's length error
4005500 passed through the CS13 during
dispense operation
Abnormal
4005600
solenoid 1 during dispense operation.
Sum check error of note index setting
4005700 value in the CDU CST of EEPROM
during initializing
Cause
OUT (JAM)(Separated
(CS11AB, CS21AB,
operation of the gate
1. Check received command
2. Check communication cable
3. Check CDU Firmware Version
1. Remove jammed notes on CDU return path
2. Remove dust in CS11AB, CS21AB, CS31AB,
CS41AB, CS4AB, CS13 Sensor
3. Install after rearranging notes in cassette
1. Check state of notes in reject box
2. Rearrange notes in cassette
3. Check Index of notes
4. Check foreign objects in the main motor encoder slit.
5. Replace the CS8 encoder slit sensor
1. Initialize after removing the return path
2. Clean sensors on the return path (CS13)
1. Check the CDU received command
2. Check the abnormal communication cable.
3. Check the CDU firmwave version and refer to
specifications.
1. Remove the remaining notes at a sensor in front of the
CST
2. Realign notes in the cassette
3. Check abnormal clutch.
4. Check abrasion of the cassette box pick unit.
1. Remove a jammed note between the tray and CDU
2. Remove a jammed note at the position of the CS13
sensor
3. Remove a dust on the CS13 sensor
1. Remove a jammed note on the gate
2. Remove notes in the reject box and remount the reject
box
3. Check if the CS3 sensor bracket is bended.
4. Check if the CS3 sensor cable is disconnected
5. Exchange a sensor after abnormal operating CS3
Gate detecting sensor.
6. Replace the reject solenoid 1
1. Read the CDU version to check CDU CST note index
2. Reinitialize
3. Initialize after executing the CDU Information Set('P')
Command
4. Replace the CDU board
6 - 29
6. Appendix
Handling