HYOSUNG MoniMax 5600T Operator's Manual page 118

MoniMax 5600T
Error Code
To show that the discordance of write
3002900
data has happened in write verify.
To show that power down(or power cut in
3003000 short
detected).
To show that DSR signal was turned to
3003100
OFF(communication is cut)
To show that the card was pulled out
3004000 form ICRW through entrance date when
CAPTURE command is being executed.
Failure at IC Contact solenoid or sensor
3004100
ICD.
Card could not be set to IC contack
3004300
position/Failure at sensor PDI.
ICRW lost sight of the card when ICRW
completed to carrry the card to dhe rear
3004500
position during the card acceptance, and
ICRW ejected the card to entrance gate.
To show that the ejected card has not
3004600 been withdrawn during execution of
Monitoring for removal command.
3005000 Retract counter overflow.
To show that Motor error has happened,
3005100 through start/stop check in Initialize
command.
To show that read error in Digital Decode
3005300
Read Command.
To show that there found abnormal
3006000
condition on the power-line.
3006100 The receiving error for ATR.
To show that the specified protocol does
3006200 not agree with that of ICC/SAM ICRW still
connected.
Cause
instant)is detected(or being
6 - 23
6. Appendix
Handling