HYOSUNG MoniMax 5600T Operator's Manual page 115

MoniMax 5600T
Error Code
2080700
Receipt paper runs out of after printing
It is detected that paper is not properly
2080800
cut while operating
Black mark is not properly detected in
2080900
receipt paper after printing
The size of image print data is abnormal
2080A00
while printing image
Failed to communicate with Receipt
9720000
printer when connected to SP open
Failed
2DN0000
between Receipt printer and SP
2080F00 The firmware crashed
2080B00 Margin setting error
2080C00 Paper jammed at the exit of the slot
2080D00 Paper jammed in the path
Hardware
9720100
executing command
Cause
to connect communication
error occurred
1.Replenish receipt paper in paper charger
2.Check the status of Near End sensor and its
connctor
1.Check the Cutter module
2.Check if printer head lever is properly close
1.Check the status of Black mark sensor
2.Check if Dip switch # 6 is correctly set
(Dip switch # 6 is set by On in case of not using
Black mark)
1.Check the AP version and initialize
1.Check if communication cable or com port is not
connected
1.Check if communication cable or com port is not
connected
1. Check whether the dip switch #1 is set to "ON"
position
2. Update the firmware
1. Check whether the default registry setting is
changed
2. Reset the PTR SP
1. Remove the jammed paper
1. Remove the jammed paper
before
1. Reset the PTR SP
6 - 20
6. Appendix
Handling