Troubleshooting - Kogan KAGFLWAS10A User Manual

TROUBLESHOOTING

Error
Problem
Code
"E01" is on
The machine
the
fills overtime.
screen.
There is a "E02" is
Door lock on the
alarm. screen.
The machine "E03" is
drains on the
overtime. screen.
Water
overflows the
"E04" is
machine.
on the
/ Water sensor
screen.
works
abnormal.
"E05" is
The motor
on the
does not work.
screen.
There is a "E06" is
heating tube on the
fault. screen.
There is a "E07" is
temperature on the
sensor fault. screen.
"E09" is
There is a
on the
signal fault.
screen.
Possible Cause
1. The water tap is not open.
2. The drain hose is put down.
3. The water inlet valve is
damaged.
1. The door is not locked well.
2. A garment is caught
between the door and the
seal.
3. The door lock is damaged.
1. The drain hose is squashed
or kinked.
2. The drain pump filter is
blocked.
3. The drainage system pipes
are blocked.
1. The water inlet valve is
damaged.
2. The connection between
the water sensor and the wire
is not secure.
3. The water sensor is
damaged.
1. The connection between
the motor and the wire is not
secure.
2. The motor is protected
because of over-heat.
3. The motor is damaged.
1. The connection between
the heating tube and the wire
is not secure.
2. The heating tube is
damaged.
1. The connection between
the temperature sensor and
the wire is not secure.
2. The temperature sensor is
damaged.
1. The signal transmission
failed
Solutions
1. Open the water tap.
2. Hook up the hose.
3. Change the water inlet valve.
1. Lock the door well.
2. Put the garment into the drum.
3. Change the door lock.
1. Check the drain hose.
2. Clean the filter.
3. Check the drainage system and
clean it.
1. Change the water inlet.
2. Check the connection and
ensure it is secure.
3. Change the water sensor.
1. Check the connection and
ensure it is secure.
2. Check if the machine is
overloaded. Switch off the
machine and retry when the
motor becomes cool.
3. Change the motor.
1. Check the connection and
ensure it is secure.
2. Change the heating tube.
1. Check the connection and
ensure it is secure.
2. Change the temperature
sensor.
1. Restart the machine