Drain hose connection
1. Direct into a sink:
If the outlet spigot has not been used before, remove the blanking plug (if present).
•
Push the drain hose onto the spigot and secure with a clip if required, ensure a loop
•
is formed in the drain hose to prevent any waste from the sink entering the washing
machine.
If required, the drain hose can be extended to a length of 4m.
•
2. Connected securely to a standpipe:
Firstly, form a hook shape at the end of the drain hose using the supplied "U"
•
piece".
Place the drain hose into the standpipe, which should have an internal diameter of
•
approximately 38mm thus ensuring there is an air brake between the drain hose
and standpipe.
When discharging into a standpipe ensure that the top of the standpipe Is no more
•
than 90cm and no less than 60cm above floor level.
"U" Piece
Loop