Kogan KAGFLWAS10A User Manual page 14

Water inlet connection
1. Connect the supplied inlet hose to a tap with a 3/4" thread.
2. Do not use any old existing hoses.
3. Installation should comply with your local water authority and building regulations'
requirements.
When there is a single inlet valve at the back of the machine, it must be connected to a
cold-water supply. If there are two inlet valves, one is connected to a cold-water supply and
the other is connected to a hot-water supply. Follow the indication of the picture below to
complete the connection.
Washing preparation
1. Connect the inlet hoses and turn on the tap.
2. After making sure the power socket is grounded reliably, insert the power plug into
the power socket. Switch on at wall.
3. Position the drainage hose (laundry sink or drain).
How to use Washer
Before washing close for the first time, you must run a complete cycle without clothes.
1. Turn the program select knob to "Standard" position.
2. Press "Start/Pause" button.
If there is any water leftover from quality testing, this will drain the water.
Cold Water Inlet valve
Inlet Hose with white nut