Sabo 43-COMPACT Manual page 41

Operator's manual (116 pages)

Operator's manual (96 pages)

Table of Contents

Available languages

Pos: 20.13 /Innenteil/Wartung des Motors/1.1 Kontrolle der Zündkerze (Abbildung Y ) @ 0\mod_1115369306250_1521.docx @ 1865 @ 2 @ 1

Checking the spark plug (Illustration Y )

Pos: 20.14 /Innenteil/Wartung des Motors/Kontrolle der Zündkerze Text 0,7mm @ 0\mod_1115369340031_1521.docx @ 1873 @ 2 @ 1

To check for wear, remove the spark plug connector and unscrew the spark plug. If the

electrode is badly worn the spark plug must be replaced as a matter of course. (Order

no. see original spare parts list and accessories).

Otherwise it is sufficient to clean the spark plug and set the electrode gap to 0.7 mm.

Screw the spark plug (pay attention to sealing ring) into the engine by hand and tighten

using the socket wrench. Press on spark plug connector. Replace the spark plug

annually.

Pos: 20.15 /Innenteil/Wartung des Motors/1.1 Vorschriftsmäßiges „Überwintern" des Motors (oder längerer Nichtgebrauch) @ 0\mod_1115369429437_1521.docx @ 1869 @ 2 @ 1

Correct winter storage of the engine (or when not used for a long period

of time)

Pos: 20.16 /Innenteil/Wartung des Motors/Vorschriftsmäßiges „Überwintern" des Motors Gerät kippen Text @ 0\mod_1115369463687_1521.docx @ 1878 @ @ 1

–

Empty the petrol tank or allow the engine to run until it stops due to lack of fuel.

–

Switch off engine and disconnect spark plug cable.

–

Drain off the oil while the engine is still warm. Fill with fresh oil (for quantity and

type, see technical data).

–

Clean grass and chaff from cylinder and cylinder head fins and around muffler.

–

Always keep the machine in a clean condition in a closed, dry room out of reach of

children.

Pos: 21.1 /---------- 1 Leerzeile ---------- @ 0\mod_1114611787140_1521.docx @ 2070 @ 1 @ 1

Pos: 21.2 /Innenteil/Störungsursachen und deren Beseitigung/1 STÖRUNGSURSACHEN UND DEREN BESEITIGUNG @ 0\mod_1115373523343_1521.docx @ 1904 @ 1 @ 1

18 TROUBLESHOOTING

Pos: 21.3.1 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/1 Tabellenkopf @ 0\mod_1115374760156_1521.docx @ 1884 @ @ 1

Fault

Pos: 21.3.2 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/Motor springt nicht an E-Start 43er, 47er, 54er (fix speed) MUSTER @ 17\mod_1331727762233_1521.docx @ 134576 @ @ 1

Engine does not start

Pos: 21.3.3 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/Motorleistung lässt nach @ 0\mod_1127909215694_1521.docx @ 1896 @ @ 1

Engine performance

decreases

Pos: 21.3.4 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/Motor läuft unregelmäßig @ 0\mod_1127909273145_1521.docx @ 1891 @ @ 1

Engine runs irregularly

Pos: 21.3.5 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/Starke Erschütterungen (Vibrieren) @ 0\mod_1115377318234_1521.docx @ 1900 @ @ 1

Extreme vibration

Heruntergeladen von

manualslib.de

Possible cause

Remedy

Control handle not

Press the control handle onto

turned down.

the upper part of the bar D .

Fuel tank empty.

Fill up with clean and fresh

fuel.

Spark plug connector

Push plug connector in place

loose.

or have it checked by an

authorised workshop.

Spark plug defective or

Replace or clean spark plug,

soiled or electrodes worn

set electrode distance to 0.7

out.

mm Y .

Too much petrol feed to

Have it checked by an

engine (spark plug wet).

authorised workshop.

Air filter soiled.

Clean or replace air filter

insert W .

Battery not charged (only

Charge battery W1 , X1 .

for electro-start).

Start-up takes longer

If you experience start

than 5 seconds or is

difficulties, contrary to

repeated too often (only

expectations, the battery

for electro-start).

must also be charged in

between.

Connection cable

Connect the battery

between the ignition key,

connector with the mating

battery and engine is

connector on the harness

loose or without contact

U1 or check it or have it

(only for electro-start).

checked by an authorised

workshop.

Air filter dirty.

Clean or replace air filter

insert W .

Spark plug contaminated

Have it cleaned by an

with soot.

authorized dealer.

Air filter dirty.

Clean or replace air filter

insert W .

Spark plug contaminated

Have it cleaned by an

with soot.

authorized dealer.

Have it checked by an

authorized dealer.

Have it checked by an

authorized dealer

Handbücher-Suchmachiene

Pos: 21.3.6 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/Schnitt unsauber, Rasen wird gelb, Benzin @ 0\mod_1115377468656_1521.docx @ 1898 @ @ 1

Blade blunt.

Unclean cut, lawn is

yellow

Cutting height too low.

Engine speed too low.

Mowing too fast.

Insufficient overlapping

of cuts when mowing.

Lawn becomes matted.

Pos: 21.3.7 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/Auswurf verstopft, Benzin, TurboSignal @ 0\mod_1127908095450_1521.docx @ 1886 @ @ 1

Turbo signal has not

Ejection blocked

been detected J + K .

Engine speed too low.

Cutting height too low for

grass that is too high.

Pushing mower too fast.

Grass not dry.

Pos: 21.3.8 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/Gemulchte Gras sieht schlecht aus Heckauswurf @ 5\mod_1183467132357_1521.docx @ 35950 @ @ 1

Blade blunt.

Mulched grass

appearance is poor:

clumps, excessive

clippings, rough cut.

Mulching rule not

followed (cut max. 1/3 of

the grass height; the

height of the grass to be

cut must be lower than

10 cm)

Travel speed too fast.

Grass build-up under

deck.

Insufficient overlapping

of cuts when mowing.

Grass not dry.

Pos: 21.4 /Innenteil/Störungsursachen und deren Beseitigung/Störungsursachen und deren Beseitigung Text Benzin @ 0\mod_1115378183390_1521.docx @ 1905 @ @ 1

In case of faults and defects which have not been listed here, please contact the

nearest authorized dealer.

Repairs which require specialized knowledge should only be performed by a qualified

expert. Your authorized dealer will naturally also be glad to help if you do not wish to

perform the maintenance work described here yourself.

Pos: 22.1 /---------- 1 Leerzeile ---------- @ 0\mod_1114611787140_1521.docx @ 2070 @ @ 1

Have it sharpened and

balanced by an authorized

dealer Q .

Adjust to higher cutting height

I .

Operate at max. rpm.