Power On/ Power Off - Casio DT-X200 Series Software Manual

Power On/ power Off

2.8.1
The factors which turn unit power On and Off (suspend and resume) are as follows.
(1) Power ON Factors
① Power is turned on by pressing the Power key on the unit.
② Power is turned on automatically by the Alarm function at the specified time.
③ If the terminal is placed in a cradle, it turns on automatically. (only when the cradle is powered)
④ Pressing a trigger key turns the power on. (Setup required)
⑤ Power is turned on by pressing the Reset switch.
[Caution] Power does not turn on if the following occur during the startup check.
- When main battery voltage level is insufficient to start up the terminal
- Rechargeable battery pack lock switch (the body back) is open.
(2) Power OFF factors
① Power is turned off by pressing the Power key on the unit while power is on. (This can be set as
prohibited)
② Power is turned off automatically by a software setting if there is no activity (keys, touch panel,
disk) for a set period. (APO)
③ Power is turned off by main battery voltage drop.
④ Power turns off when Rechargeable battery pack lock switch (the body back)is opened.
⑤ Power is turned off when the Power Off function is executed.
⑥ When the internal temperature of the unit (CPU temperature) rises above a certain level, a
warning is issued and then the power is turned off, to protect the unit. (Refer to the (4)
temperature restriction control section)
[Caution] If the unit is turned off by factor [3] or [6], a pop-up is displayed on the screen on the next
startup.
(3) Memory check
This checks the status of memory after power is turned on. If the memory is corrupted, the following
warning message is displayed every time the power is turned on, until a full reset is performed on
the unit.
35