Scanning Conditions - Casio DT-X200 Series Software Manual

Scanning conditions

2.9.3
Conditions that allow scanning a barcode symbology in specific modes can be set for each
readable symbology.
Readable symbology codes
Barcode symbologies that are enabled or disabled for scanning can be specified.
If only specific symbologies are to be scanned, set "Enable" for scanning on these barcode
symbologies only and "Disable" on the other symbologies. This will reduce decode processing
time and lower the error rate. The default is "Enable scanning of all symbologies".
Readable digits
The no. of digits to read can be set for each readable symbology.
If only a specific no. of digits is to be scanned, specify it for each readable symbology. This will
reduce decode processing time and lower the error rate.
Enable or disable check digit
Check digit can be set to "Enable" or "Disable" for each readable symbology.
Enabling check digit will lower the error rate.
EAN, JAN, UPC-A
EAN, JAN, UPC-A add-on
UPC-E
UPC-E add-on
Code39
NW-7
Interleaved 2 of 5
Industrial 2 of 5
Code93
*1
Code128
MSI
IATA
GS1 DataBar (Omnidirectional,
Truncated)
(RSS-14 (Truncated))
GS1 DataBar Limited
(RSS Limited)
GS1 DataBar Expanded
(RSS Expanded)
GS1 DataBar Stacked (Omnidirectional)
(RSS-14 Stacked (Omnidirectional))
GS1 DataBar Expanded Stacked
(RSS Expanded Stacked)
Barcode Check digit calculation
Valid
Valid
Valid
Valid
Enable/ disable
Enable/ disable
Enable/ disable
Enable/ disable
Valid
Valid
Valid
Enable/ disable
Valid
Valid
Valid
Valid
Valid
45
Check digit calculation
default
Valid
Valid
Valid
Valid
Disabled
Disabled
Valid
Valid
Valid
Valid
Valid
Disabled
Valid
Valid
Valid
Valid
Valid