Casio DT-X200 Series Software Manual page 58

(*1) ISBT code is recognized as Code128.
(*2) The name of code EAN128 (UCC/EAN128) has been changed to "GS1-128".
(*3) When scanning Code32, set to enable scanning of both Code32 and Code39.
- Reading the number of scanned digits
Figures outside brackets are the numbers of readable digits. Figures inside brackets are numbers of
settable digits for the library and Control Panel. However, caution is required because the numbers
of readable digits are guideline figures, and the actual readable range depends on the error
correction level, the state of symbol printing (resolution, print density, thickness, etc.) and the
surrounding environment. Numbers of readable digits are strongly influenced by the module's focal
length. Long-distance types have long depth of field, so it is possible to fit large symbols within the
angle of view, and the number of readable digits is larger.
(2) 2D code (stacked code)
Code
PDF417
MicroPDF
Codablock F (*1)
EAN8/13 Composite
GS1 DataBar Composite
UCC/EAN128
Composite
GS1 DataBar-14
（Stacked type) (※2)
GS1 DataBar Expanded
(Stacked type)
(*1) The Codablock F code has Code128 codes superimposed vertically. Therefore if Code128
code scanning is enabled, part of the Codablock F code may be scanned as Code128.
(*2) This includes the Standard Omnidirectional type.
[Addendum] The way of reading the scanned number of digits is the same as described for a 1D
code (barcode).
Scan Check
No. of digits Character
Always
1~2000
(0~2750) enabled
1~366 Always
(0~2750) enabled
Always
1~200
(0~2048) enabled
Always
8~338
(1~2435) enabled
2~338 Always
(1~2435)
enabled
Always
6~2361
(1~2435) enabled
Always
14
enabled
Always
1~20
(1~80) enabled
58
Check
Character Remarks
output
Always
disabled
Always
disabled
Always
disabled
Always EAN8/EAN13
disabled + MicroPDF
Always RSS (1D)
disabled + MicroPDF
EAN128
Always
+ MicroPDF or
disabled
PDF417
Always
disabled
Always
disabled