Connecting Power Supply To Ha-D60Io, Ha-D62Io; Ha-D60Io - Casio IT-600 Series Quick Start Manual

4. Connecting Power Supply to HA-D60IO, HA-D62IO

4.1 HA-D60IO

Use the dedicated AC adaptor (AD-S42120B) for power supply to the HA-D60IO USB cradle.
Make sure to connect the AC adaptor to the USB cradle before starting communication between the
IT-600 and PC via the cradle. Follow the steps below to set power supply to the IT-600 using the
dedicated AC adaptor.
1. Plug the AC adaptor into the AC adaptor jack where "DCIN12V" is printed by on the back of
the cradle. See Figure 4.1.
Figure 4.1
2. After connecting the power cable to the AC adaptor, plug in the plug to an electrical outlet.
3. Make sure the selector switch on the back of the cradle is set to position B.
Figure 4.2
4. Connect USB cable (DT-380USB) to USB client port on the back of the cradle, and then
connect the other end of the cable to PC. USB host port is used when connecting the cradle
with other USB peripheral device.
5. Align the USB cradle mount holes on the back of the IT-600 with the mount hooks on the
cradle after aligning the contacts on the bottom of the IT-600 with the power contacts of the
cradle. The power indicator LED on the front of the cradle will light in green if the IT-600 has
been properly mounted.
Set to B
24