Set Lan; Lan Cradle Setting Tool - Casio DT-X200 Series Software Manual

3.9 Set LAN

LAN Cradle Setting Tool

3.9.1
This tool sets IP information for the terminal LAN cradle.
Select Start -> Settings -> Control Panel -> LAN Cradle.
(1) Settings screen
The settings are made from the screen shown below. The IP address, subnet mask, and default
gateway are written to the LAN cradle.
No. Item
IP Settings
1
2 Enable DHCP
Configure IP
IP
3
MASK
4
GateWay
5
Count
6
Set
7
Close
8
Content
Use the radio button to select one of the following
- Use terminal IP information (default)
- Use cradle IP information
Use the radio button to select one of the following
Enable DHCP (default)
- IP specification
Specify the IP address (required if IP specification is used). Default:
Blank.
The input range for each octet is integers in the range 0~255.
Specify the subnet mask (required). Default: Blank
The input range for each octet is integers in the range 0~255. (Example:
255.255.255.0)
Specify the default gateway (may be omitted). The input range for each
octet is integers in the range 0~255. Default: Blank
Specify the number of LAN cradles to set (may be omitted).
Inputtable number of cradles: Integer in the range 1~254. Default: Blank
Sets information as specified on the screen.
This closes the tool.
133