Installation; Mount Inverter - Sensata Dimensions 12LP15 Owner's Manual

INSTALLATION

Mount Inverter

WARNING: Power inverters produce hazardous voltages. To avoid risk of harm or fire, the unit must be
properly installed.
WARNING: Power inverters should not be mounted in a location that may be exposed to rain or spray.
WARNING: Power inverters should not be installed in a zero-clearance enclosure.
WARNING: Power inverters contain a circuit breaker and capacitor that may produce a spark upon connection
or during normal operation. Do not mount in a confined battery or gas compartment.
Installation Tools
• Wire Termination Crimper
•
Cable-Ties
• Drill
• #2 Phillips Screw Driver (with a magnetic end)
• Slotted Screw Driver
• Tape Measure
• Wire Cutters
• Needle Nose Pliers
• Wire Strippers
Inverter Mounting Recommendations
NOTE: The inverter mounting location should provide adequate ventilation and clearance to maintain room
temperature during operation. At least ½" of clearance is required on all sides except the bottom.
1. Locate a suitable, secure mounting surface as close to the batteries as possible without being in the same
compartment.
2. Mount the inverter using four ¼-20 steel bolts, flat and lock washers, and nuts. The length of the bolts should
be equal to the thickness of the mounting surface plus ¾".
Page 10
Figure 2 Mounting for All Models (Inches)
12LPC15 Manual