MOUNTING THE INVERTER
Installation Tools
The following tools may be required for inverter installation: Crimper, Cable
Ties, Cutter, Drill, #2 Phillips Screw Driver (with a magnetic end), Slotted
Screw Driver, Tape Measure, Wire Cutters, Needle Nose Pliers, and Wire
Strippers.
Inverter Mounting Recommendations
NOTE: The inverter mounting location should provide adequate ventilation and
clearance to maintain room temperature during operation. At least ½"
of clearance is required on all sides except the bottom.
1.
Locate a suitable, secure mounting surface as close to the batteries as possible
without being in the same compartment.
2.
Mount the inverter using four each ¼-20 steel bolts, flat and lock washers, and
nuts. The length of the bolts should be equal to the mounting material
thickness plus ¾".
Figure 2 - Mounting for all models (units are in inches)
122221 12LPC15 Manual Rev A.docx
8