Life Fitness Axiom OP-SLCE Assembly Instructions Manual page 34

7. Slide shaft collar and roller pad assembly onto the thigh pad assembly.
8. Install screw and plate securing the roller pad assembly to the thigh pad assembly using an 8mm Allen wrench.
9. Install bearing housing cap to the roller pad assembly using a rubber mallet.
10. Tighten set screws in the shaft collar to 8-10 ft-lb (10.8-13.5 Nm) using a 4mm Allen wrench.
11. Install screws and washers securing the seat pad to the main frame assembly using an 8mm Allen wrench.
12. Pull detent pin out and slide seat back assembly into the main frame assembly.
TIP: Break-Free CLP can be used to lubricate the seat back assembly. Spray Break-Free CLP, or apply with a cloth,
to the plated back adjustment post.
Item
1
2
3
4
5
6
Tighten hardware to 40-50 in-lb (4.5-5.6 Nm).
Item
1
2
3
4
Tighten hardware to 40-50 in-lb (4.5-5.6 Nm).
Item
1
2
Page 32 of 41
Description
Roller Pad Assembly
Thigh Pad Assembly
Shaft Collar
Roller Pad Plate
Screw, M10 x 1.5, 35mm
Bearing Housing Cap
Description
Seat Pad
Main Frame Assembly
Screw, M10 x 1.5, 30mm
Washer, Flat 3/8"
Description
Seat Back Assembly
Main Frame Assembly
Qty.
1
1
1
1
1
1
Qty.
1
1
4
4
Qty.
1
1