Life Fitness Axiom OP-SLCE Assembly Instructions Manual page 33

Install Pads
1. Place spring pin on the end of the detent shaft.
2. Thread detent shaft into the kicker assembly.
3. Slide shaft collar and roller pad assembly onto the kicker assembly.
4. Place retainer plate and bearing housing cap over the detent pin assembly and thread the detent pin assembly
into the kicker assembly.
5. Tighten set screws in the shaft collar to 8-10 ft-lb (10.8-13.5 Nm) using a 4mm Allen wrench.
6. Install screw and washer securing the kicker assembly to the work arm assembly using a 7mm Allen wrench.
Item
1
2
Item
1
2
3
4
5
6 Bearing Housing Cap with Hole
7
Item
1
2
3 Screw, M10 x 1.5, 30mm Low Head
4 Washer, 3/8" ID x 1.25" OD
Tighten hardware to 20-25 ft-lb (27.1-33.9 Nm).
Page 31 of 41
Description
Spring Pin
Detent Shaft
Description
Detent Shaft
Shaft Collar
Kicker Assembly
Roller Pad Assembly
Retainer Plate
Detent Pin Assembly
Description
Kicker Assembly
Work Arm Assembly
Qty.
1
1
Qty.
1
1
1
1
1
1
1
Qty.
1
1
1
1