Life Fitness Axiom OP-SLCE Assembly Instructions Manual page 27

4. Slide bearing housing caps, .403 spacers, work arm assembly, .653 spacers, cam assembly, and pulley arm
assembly onto the pivot shaft.
NOTE: Make sure pulley arm assembly is aligned to rest on top of the bumper bracket on the cam assembly.
5. Press bearing housing caps onto the bearing housings of the work arm assembly and pulley arm assembly.
6. Install screws and washers securing the counter weight to the work arm assembly using an 8mm Allen wrench.
Item
1
2 Bearing Housing Cap with Hole
3
4
5
6
7
Item
1
2
3
4
Tighten hardware to 14-16 ft-lb (19-21.7 Nm).
Page 25 of 41
Description
Pivot Shaft
Spacer, .403"
Work Arm Assembly
Spacer, .653"
Cam Assembly
Pulley Arm Assembly
Description
Counter Weight
Work Arm Assembly
Screw, M10 x 1.5, 35mm
Washer, Flat 3/8"
Qty.
1
2
2
1
2
1
1
Qty.
1
1
2
2