Life Fitness Axiom OP-SLCE Assembly Instructions Manual page 28

7. Install screw and washer securing the thigh pad assembly to the pivot boom assembly using a 7mm Allen wrench.
8. Install bearing housing cap to the pivot boom assembly using a rubber mallet.
Cable Routing
1. Route cable out through the hole on the side of the tower frame. Route cable through the pulley support assembly.
2. Slide the carriage bolt to the end of the slot in the pulley support assembly using a 17mm wrench.
3. Slide pulley support assembly onto the pivot shaft and align with holes in the tower frame.
NOTE: Press the pivot shaft into the pulley arm assembly so approximately ¼" is exposed to get the pulley support
assembly to align with the tower frame.
Item
1
2
3 Screw, M10 x 1.5, 30mm Low Head
4
5
Tighten hardware to 14-16 ft-lb (19-21.7 Nm).
Item
1 Carriage Bolt, M10 x 1.5, 50mm
Tighten hardware to 20-25 ft-lb (27.1-33.9 Nm).
Page 26 of 41
Description
Thigh Pad Assembly
Pivot Boom Assembly
Washer, Flat 30mm
Bearing Housing Cap
Description
Qty.
1
1
1
1
1
Qty.
1