Finalizing The Configuration; Adding The Probe And The Power Supply - LogTag Recorders UTREL30-16 Product User Manual

30-day low-temperature data logger with display

Table of Contents

Preparing a UTREL30-16 for first use

UTREL30-16 User Guide

Finalizing the configuration

Click

Configure

to upload the configuration data to the UTREL30-16.

When the configuration is complete, unplug the UTREL30-16 from the USB socket and

replace the protective seal.

If you wish to configure more UTREL30-16 units with the same configuration, insert the

next loggers into USB sockets, wait until they are ready for configuration and click

Repeat

Configure. Alternatively, you can use the

Profile

function to configure multiple units with

the same settings.

You can upload the configuration to a UTREL30-16 logger as often as required.

Before the UTREL30-16 can record temperature data you will need to connect an external

probe.

The UTREL30-16 accepts any ST10 probe (including an STX50 extension). Plug the probe

connector into the socket located at the bottom of the device, as shown.

For stationary applications we recommend you connect a power

supply (see

Powering the

UTREL30-16).

Remove the protective cap and insert the USB connector.

Note that the wider part of the connector is oriented towards

the rear of the product.

Table of Contents

Do you have a question about the UTREL30-16 and is the answer not in the manual?