LogTag Recorders UTREL30-16 Product User Manual page 14

Preparing a UTREL30-16 for first use
The logger is unconfigured
An unconfigured UTREL30-16 logger is delivered to you hibernated (i.e. in a state of low
power consumption), and pressing the
If your logger is unconfigured you must set it up with the parameters required for
starting and recording temperature values;
l
printing the PDF;
l
triggering alarms.
l
This is done using LogTag
analyzing data.
Start the LogTag
l
Remove the protective cap from the logger's USB socket and plug the Micro USB end
l
of the cable into the socket. Plug the other end of the cable into a USB socket on your
computer and wait for the drivers to be installed
From the menu click LogTag - Configure; LogTag
l
configuration options for connected loggers.
1
You can configure more than one UTREL30-16 at the same time, however it is practical to limit the number of units to about 6,
using a powered USB hub.
UTREL30-16 User Guide
REVIEW
and then
®
Analyzer software, which can also be used for downloading and
®
Analyzer software.
shows:
/MARK
1
.
®
Analyzer will display the
14