Fcc Notices (U.s. Only - Dell PowerVault 130T User Manual

system should match the electromagnetic environment classification of the computer
system.
NOTE: A Notice About Shielded Signal Cables: Use only shielded cables for connecting
peripherals to any Dell device to reduce the possibility of interference with radio
communications services. Using shielded cables ensures that you maintain the
appropriate EMC classification for the intended environment. For parallel printers, a cable is
available from Dell Computer Corporation. If you prefer, you can order a cable from Dell
Computer Corporation on the World Wide Web at http://www.dell.com/products/dellware/
index.htm.

FCC Notices (U.S. Only)

FCC regulations provide that changes or modifications not expressly approved by Dell
Computer Corporation could void your authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
•
This device may not cause harmful interference.
•
This device must accept any interference received, including interference that may
cause undesired operation.
Class A
This equipment has been tested and found to comply with the limits for a Class A digital
device pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the manufacturer's instruction
manual, may cause harmful interference with radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in which case you
will be required to correct the interference at your own expense.
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/television technician for help.