Table of Contents
Advertisement
To get help with your Dell BOSS-N1, you can contact your Dell Technical Service representative or see
support.
Topics:
•
BOSS-N1 supports only single drive RAID 0
•
Unwanted 0.0 MB unallocated space entry on BOSS-N1
•
BOSS-N1 HII displays Maximum VD supported as 2
•
RAID level (between RAID 0 and RAID 1) migration is not supported on BOSS-N1
BOSS-N1 supports only single drive RAID 0
Issue:
BOSS-N1 allows physical connections of two M.2 NVMe drives. However, only one M.2 NVMe drive is
used to create RAID 0 volume and the other M.2 NVMe drive is not used.
Corrective
Expected behavior. No action is required.
Action:
Unwanted 0.0 MB unallocated space entry on BOSS-
N1
Issue:
If no RAID is created on drives connected to BOSS-N1 controller, one unwanted entry of 0.0 MB
unallocated space is displayed in the disk selection page during installation of the Windows operating
system.
Corrective
Expected behavior. No action is required.
Action:
BOSS-N1 HII displays Maximum VD supported as 2
Issue:
BOSS-N1 HII displays Maximum VD supported as 2. Considering one functional VD and one foreign VD,
HII displays Maximum VD supported as 2.
Corrective
Expected behavior. No action is required.
Action:
RAID level (between RAID 0 and RAID 1) migration is
not supported on BOSS-N1
Issue:
BOSS-N1 allows physical connections of two M.2 NVMe drives. Either you can create single drive RAID 0
or two drive RAID 1. After this RAID operation, RAID level migration is not supported.
Corrective
Expected behavior. No action is required.
Action:
32
Troubleshooting
Troubleshooting
https://www.dell.com/
9
Advertisement
Table of Contents
