Dell PowerVault 130T User Manual page 41

Drive Operational Status Messages
Message
Wrt Prot
Loaded
Unloaded
Not Installed
A typical status display looks like the example below.
CAP Locked
Not Installed
DLT4000 Loaded
DLT4000 Unloaded
In this example, the message lines indicate:
Message Lines
Line Number
(Line 1)
(Line 2)
(Line 3)
(Line 4)
NOTE: If the library contains four DLT drives (the fourth in slot 3 at the top), you can see
the status of the fourth drive by pressing the up arrow on the operator panel to allow the
drive status lines to scroll.
Description
The cartridge loaded in the drive is write protected.
A cartridge tape is loaded in the drive.
No cartridge tape is loaded in the drive.
No DLT drive is installed in that slot.
Line 1
Line 2
Line 3
Line 4
Description
The Cartridge Access Port (CAP) is locked.
Drive slot 2 is empty (third slot from bottom in the library).
Drive slot 1 (second from bottom) contains an installed
DLT4000 drive that is loaded with a cartridge tape. If a DLT
7000 drive is installed, this will display in place of DLT4000.
Drive slot 0 (bottom) contains an installed DLT4000 drive
that is not loaded with a cartridge tape. If a DLT7000 drive is
installed, this will display in place of DLT4000.
Operating the PowerVault 130T 3-5