Adjusting The Parallelism Of The Cutting Unit; Removing The Cutting Unit - Husqvarna R 214T AWD Operator's Manual

Adjusting the parallelism of the
cutting unit
1 Remove the front cover.
2 Unscrew the belt shield.
3 Undo the nuts on the lift strut.
4 Screw out (extend) the stay to raise the rear edge of the
cover.
Screw in (shorten) the stay to lower the rear edge of the
cover.
5 Tighten the nuts after adjustment.
6 On completion of the adjustment the unit's parallelism
should be re-checked.
7 Screw on the belt shield.
8 Fit the right-hand fender and the front hood.
Maintenance

Removing the cutting unit

!
To remove the cutting deck proceed as follows:
1 Position the machine on flat ground. Apply and lock the
parking brake. Set the cutting height control in the lowest
position and lift up the cutting unit.
2 Release the clip on the front hood and lift off the fender.
3 Loosen on the cutting height stay and place in the holder.
4 Loosen the spring on the drive belt's belt idler by pulling
the spring eye.
5 Place the spring eye in the holder.
WARNING! Wear protective glasses when
dismantling the cutting unit. The spring
which tensions up the belt may break and
cause personal injury.
– 23
English